NSE6_FWF-6.4 Fortinet NSE 6 - Secure Wireless LAN 6.4 Questions and Answers

The wireless network interface must be assigned a Layer 3 address because it acts as the gateway for the tunnel mode SSID traffic. The FortiGate wireless controller uses this interface to communicate with the FortiAPs and the wireless clients. Without a valid IP address, the tunnel mode SSID cannot function properly. References: Secure Wireless LAN Course Description, page 5; [FortiOS 6.4.0 Handbook - Wireless Controller], page 24.

The RADIUS user attributes used for the VLAN ID assignment are:

IETF 64 (Tunnel Type)—Set this to VLAN.

IETF 65 (Tunnel Medium Type)—Set this to 802

IETF 81 (Tunnel Private Group ID)—Set this to VLAN ID.

(Page 88 Study Guide) "FortiPresence provides data and analytics based on demographic segmentation and visitor movement between areas"

According to the web search results, FortiPresence location map functionality provides real-time insight into user movements. It uses the location data from the Fortinet access points to detect each visitor’s smartphone Wi-Fi signal and track their location and behavior within the site. It also provides data visualization in a customizable format, such as heat maps and animated flows, to show the visitor traffic and movement patterns. This geographical data analysis can help improve visitor experiences and business outcomes. References: Location Analytics | FortiPresence 22.4.0 - Fortinet Documentation, FortiPresence Data Sheet

https://docs.fortinet.com/document/fortipresence-vm/1.2.0/administration-guide/546812/introduction

According to the web search results, Auto TX Power control is a feature that allows the AP to automatically adjust its transmission power based on the RF environment. The goal is to minimize interference and optimize coverage cells for roaming. When the AP detects any other wireless signal stronger than -70 dBm, it means that there is a potential source of interference nearby, so it will reduce its transmission power until it reaches the minimum configured TX power limit. This will reduce the interference and improve coexistence with other devices. When the AP detects any interference from a trusted neighboring AP stronger than -70 dBm, it means that there is a high density of APs in the area, so it will also reduce its transmission power until it reaches the minimum configured TX power limit. This will balance the load and avoid overlapping coverage areas. References: AP Transmit Power and Enable Power Reduction with Auto TX, Transmit Power and Antenna Configuration, Meraki Auto RF: Wi-Fi Channel and Power Management