H35-460 HCS-5G RAN V1.0 Questions and Answers

In the 5G network test, what is the test distance between the CPE and the gNB on the terminal side?

Which of the following boards cannot be reset by command?

How many PCIs does the 5G cell support?

Which of the following protocols/data falls under Tier 3?

Which of the following does not belong to the BBU board?

In the GL to GL+NR (BBU39XO+BBU5900) evolution path, which of the following devices does not need to be added?

The VLNA group mode of gNodeB can tag different traffic with VLAN tags based on service type.

AAU/RRU and BBU fronthaul fiber is less than 100 meters, mostly used in CRAN centralized site solutions.

Which of the following MML commands supports unblocking gNodeB cells?

5G Huawei CPE How long does it take to press the reset button to restore factory settings?

If the NR base station cannot load the new BTS5900 base station configuration data at the remote end, which of the following solutions can be used for near-end data configuration?

When gNodeB configures the UBBPfw1 baseband board, how many "slot numbers" cannot be configured?

Co-MPT means that each standard is deployed on the same BTS Node and is uniformly connected to OMC management.

gNodeB implements X2 self-configuration via MME.

To enable data distribution with NR base stations in NSA networks, you need to configure the default bearer mode of NSA DC to SCG_SPLIT_BEARER on the NR side

Which of the following objects cannot be blocked with BLK?

In which of the following states is the gNodeB maintenance mode referred to as an engineering state?

What is the application type used for gNodeB remote maintenance channel detection?

AAU5613 can operate in the 3.5Ghz band.

What is the maximum MIMO supported by the 5G Indoor CPE design?

When NSA selects and interprets the 2.6Ghz band networking, the uplink and downlink decoupling scheme can not be used.

In version 5G RAN 2.0, how many 100MHz NR cells does AAU5613 support?

gNodeB The order in which hardware devices are added is "cabinet->chassis-> single board->RF unit".

In the 5G network test, what is the recommended test distance between the CPE and the gNB on the terminal side?

Which module is used in the base station power system to monitor the power environment?

In order to support the NSA DC feature on the base station, which of the following options need to be configured?

Which channel is 5G used for downlink data demodulation and time-frequency synchronization?

When debugging the NR base station through the near end of the USB flash drive, which of the following conditions will cause the RU indicator of the main control board to be in the "load failed" state?

The MCC and MNC information added by gNodeB in the SA architecture should be consistent with the core network PLMN information.