Dumpsbuddy logo
When performing an installation you notice DHCP has set your Management Server subnet mask to 255.255.255.252. Based on EMC best practices, what is the appropriate subnet mask value for Management Server network 128.221.252.0?
In Unisphere for VPLEX, which storage array does not require a mapping file when claiming storage volumes?
When configuring a RAID-1 logging volume, what flags must be used in the command line?
Refer to the exhibit.
Which tab of the VPLEX Unisphere Management Console GUI contains a link to VPLEX product documentation?
Which is a best practice recommended for VPLEX Metro inter-cluster WAN settings?
You have added a new storage array into VPLEX, but it does not see it. Which VPLEX command will display the new storage array?
Refer to the exhibit.
What is the function of the two highlighted VPLEX VS2 modules?
Which VPLEX management NIC Interface must be connected to customer IP public LAN?
When configuring a VPLEX local cluster, according to EMC best practices, how many metadata volumes are required?
Refer to the exhibit.
You have created a Distributed Device in a VPLEX Metro system. Which VPLEX Object can be placed in a Storage View for Cluster-1?
Click on the calculator icon in the upper left corner of the screen. A customer has ordered a new VPLEX, and you are on site doing the initial installation. When creating metadata volumes for the VPLEX Local configuration, the customer asks you how much total storage is needed for the VPLEX metadata.
According to EMC best practices, what is the total minimum storage needed for this configuration?
Do virtual volumes need to be taken off-line prior to upgrading VPLEX software, and why or whynot?
Starting in Geosyncrony version 5.1 what are the minimum password requirements?
Refer to the exhibit.
You have created a Distributed Device in a VPLEX Metro. You want to confirm the volumes before performing a mobility job within the cluster. You will be moving the device to cluster 1.
Which object will be the source for this operation?
Refer to the exhibit.
NDU pre-check failed because minimal topology is in use. Which parameter can be added to the ndu start command that will allow the NDU to proceed without error in this situation?
During an installation, the physical equipment inspection reveals an ESX host used for VPLEX Witness is located in the same rack as VPLEX cluster 1 Engine.
What needs to be done?
An EMC customer wants to add a mirror to a VPLEX Local RAID 0 device. Which RAID type is created after the device attach-mirror command is issued?
Exhibit:
Which VPLEX object contains virtual-to-physical mapping information and must be stored on multiple arrays?
A VPLEX administrator claims a 100GB Storage Volume that is thin provisioned on the storage array and has 25GB physically allocated and creates a 1:1 encapsulated virtual volume. After a local data mobility job for that Virtual Volume, the storage array administrator notices that the allocated capacity has increased to 100GB. Why did this happen?
Which VPLEX component can determine the difference between a partition and a site failure of a VPLEX Metro configuration?
Refer to the exhibit.
You are planning to perform data mobility between VPLEX Clusters using the GUI. What mobility job options do you have?
A customer has a VPLEX Metro installed. They asked you to recommend a method to non-disruptively move Virtual Volumes from a storage array at Cluster 1 to a storage array at Cluster 2. What would you recommend?
TESTED 06 May 2024
